Error in past assembling

Though I had reassembled frontal strut and suspension coil spring for BC7 SUBARU Legacy LSi US model following the original construction on the spring upper support angular position, careful checking revealed that the US SUBARU factory constructed condition were not always correct. Removing dusts on upper surface of the support showed different position, so I determined to disassemble them again to set in correct designing position following "OUT" engraved marking, causing 90 degree difference. The error found on the upper spring support angular setting is not so critical as to affect on the function if the construct does not hit on wheel house surface, I dare want to correct any error as much as possible.