2011年5月10日火曜日

HDD replacement

HDD in Sotec former generation note PC was replaced, because PC refrains from performing very often unintentionally. Initial version of XP Home edition was used for operation system, then critical problem on Internet Explorer 6 occurred,impossible to version up to 7,8 to 9?
Service pack 2 was installed this morning by way of Web site, see what will happen this evening?

Any unreliable machinery and devices are not acceptable for my own ones.

The performance of them depend on the correct,precise,adequate a firm adjustment technologies.

So,the periodical replacement parts may be changed after some enough time interval of using.

80G bites HDD with old connection cost below 5,000yen, now is the time for expensive Solid State Drive datum storage system.

VW 1302 Super Beetle needs a bit more adjusting interval on Solex 34PICT3 carburetor.
Lubrication on clutch pedal construction and fucked portion is required,because I feel some slipping resistance when I step onto the clutch pedal. The cap must be removed for accel wire adjustment and the point must be checked by finger touching for lubrication.
Precise adjustment was performed on automatic choke butterfly position again,because the degree of closing of butterfly affects the idling rotation of first idle control.


I found out in the Web site that a piece of bulb and solid state diode are utilized in the fuel gauge voltage stabilizer inside of later VW Beetle, though the case are the similar with old one.
So my idea to use low drop type 3pins regulator is not always a wrong choice for the stable voltage on fuel gauge in the cluster.

0 件のコメント:

コメントを投稿