I started to construct YOSHIOKA Pegasus Acro today, and initial step for fuselage is glued up. Wooden parts are well cut by means of LASER system.
Strength and redundancy system are well considered by the professional designer, many small parts are scattered everywhere intending weight reduction.
Very gentle handling is required by some experienced and trained pilot after completion, so this model airplane is not for a beginner but for adequately experienced one.
Pegasus Acro would makes a certain promotion to be controlled well as to participate in the future stunt contests. Very light and relatively large wing area design shows incredibly specific flight.
Because have I several suitable 40 class motors prepared for Pegasus ST model, I'm looking forward to try them on new model.
By the way, Pegasus ST was destroyed after 3 years using by my trifle mistake, vertical, low altitude and motor stop lacking fuel supply, I should not get riding well too much. Loosing power with low altitude leads to a critical crash, this is the same as an actual airplane.
0 件のコメント:
コメントを投稿